11
Under the following conditions the machine will automatically stop feeding:
(Press the CLEAR/RESET key to reset after an error has been corrected)
Indication on Control panel
When the START/STOP key is pressed when there is no stock.
When the START/STOP key is pressed while the paper feed
lever is in the up position.
When stock runs out while folding in the Subtraction Counting Mode.
When a mis-feed occurs.
When paper jam occurs at Table 1 and Table 2.
When Roller cover is opened.
When paper stack (exit) table is full.
When paper jam occurs at the paper exit.
Clearing a Paper Jam:
Should a paper jam occur, set the POWER switch to the OFF position and remove the jammed sheet(s).
When the jammed paper is wrapped around the fold roller or other parts, it can be easily removed by
detaching Tables 1 and 2 from the unit.
Note:
When the roller cover is opened, the machine will automatically stop operation.
To Next Page
Loading...
Need help?
General
