EasyManua.ls Logo

MC 501 - Unit Placement Guidelines

MC 501
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
2
A. General
1. Accessories
Your new MC Elegance Line component comes with a multi-usable system remote control for your conve-
nience. It can be used to control any or all of the MC product range including the preamplifier, CD player,
power amplifier and integrated amplifier.
The system remote control is not included in the delivery of the MC power amplifier.
2. Placement
Please ensure that there is sufficient ventilation and flow of air on all sides of the unit. There must be a minimum
space of 2 cm (approx. 1”) above all MC amplifiers to allow for excessive heat to escape.
In case you wish to operate two or more amps, you can stack them, place them on shelves, or fit them under
a cabinet.
Notice: Never completely cover or operate the amp in a place with insufficient flow of air. If you do, the amp
may overheat.
3. Maintenance
Unplug the unit before cleaning!
To clean the exterior surfaces of your MC unit use a dry, soft cloth. To wipe off finger prints and other grease
spots, use a soft, wet cloth moistened with a mild detergent dissolved in water.
Caution: The cloth must never be dripping wet! If water or other fluids enter the cabinet, you risk to damage
the unit.
Never use scouring pads, steel wool, scouring powders or harsh chemical agents, alcohol, thinners, benzine,
insecticide or other volatile substances, as these will destroy the finish of the cabinet.
General