EasyManua.ls Logo

McAfee NS7200 - Page 12

McAfee NS7200
16 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
c
Optional, but recommended. Change the Sensor password. At the prompt, type: passwd.The Sensor
prompts you to enter the new password and prompts you for the old password.
A password must contain between 8–25 characters, is case sensitive, and can consist of any
alphanumeric character or symbol.
d
Set the name of the Sensor:
You can enter the setup command at the prompt. This automatically prompts you to provide
the information shown in items d through g and item j. Alternatively, you can use the set
command. If you use the set command, manually enter the complete command syntax as
shown in items d through g and item j.
At the prompt, type: set sensor name <word>.
Example: set sensor name HR_sensor1
The Sensor name is a case-sensitive character string up to 25 characters. The string can include
hyphens, underscores, and periods, and must begin with a letter.
e
If the Sensor is not on the same network as the Manager, set the address of the default Gateway. At the
prompt, type: set sensor gateway <A.B.C.D>
Example: set sensor gateway 192.168.3.68
f
Set the IP address of the Manager server. At the prompt, type: set manager ip <A.B.C.D>.
Example: set manager ip 192.168.2.8
g
Set the IP address and subnet mask of the Sensor. At the prompt, type: set sensor ip <A.B.C.D>
<E.F.G.H>.
Example: set sensor ip 192.168.2.12 255.255.255.0
Specify an IP address using four octets separated by periods: X.X.X.X, where X is a number
between 0 and 255, followed by a subnet mask in the same format.
h
If prompted, reboot the Sensor. Type: reboot
The Sensor can take up to ve minutes to complete its reboot.
i
Ping the Manager from the Sensor to determine if your
conguration settings to this point have
successfully established the Sensor on the network. At the prompt, type:
ping <manager IP address>.
If the ping is successful, continue with the following steps. If not, type show to verify your conguration
settings and check that the information is correct.
j
Set the shared secret key value for the Sensor. At the prompt, type:
12

Related product manuals