McCulloch CS410 Elite User Manual

3. Push the air purge bulb (B) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
4.
Continue to To start the product on page 14 for
more instructions.
To prepare to start with a cold engine CS450
Elite
WARNING: The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up, to set it in
choke position.
C
B
A
3. Push the decompression valve (B).
Note: The decompression valve moves to the
initial position when the product starts.
4. Push the air purge bulb (C) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
5.
Continue to To start the product on page 14 for
more instructions.
To prepare to start with a warm engine CS410
Elite
WARNING: The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
2. Pull the start/stop switch (A) out and up, to set it in
choke position.
A
B
C
3. Push the air purge bulb (B) approximately 6 times or
until fuel starts to fill the bulb. It is not necessary to
fill the air purge bulb fully.
4.
Push the start/stop switch down (C).
5. Continue to
To start the product on page 14 for
more instructions.
To prepare start with a warm engine CS450
Elite
WARNING: The chain brake must be
engaged when the product is started to
decrease the risk of injury.
1. Move the front hand guard forward to engage the
chain brake.
1733 - 002 - 23.11.2021 13

McCulloch CS410 Elite Specifications

General

Brand	McCulloch
Model	CS410 Elite
Category	Chainsaw
Language	English