15
20. To save the new name, press and hold in the IN-
PUT Control until “SETUP: MEDIA BRDG , ON
/ Rename” appears on the Front Panel Information
Display. Refer to figure 20.
21. Exit the SETUP Mode by several presses of the
INPUT Control.
Note: For convenience, an “Input Assignment Chart”
on a separate sheet “Mc5A/5B” has been pro-
vided to keep track of changes.
Figure 15
RENAME: BAL 1
>MEDIA <
Figure 16
RENAME: BAL 1
>MEDIA B <
Figure 17
RENAME: BAL 1
>MEDIA BR <
Figure 18
RENAME: BAL 1
>MEDIA BRD <
Figure 19
RENAME: BAL 1
>MEDIA BRDG <
The Output Settings provide the ability to change how
the C2600 Output 1, Output 2 and Headphones func-
tion.
OUTPUT 1 and 2:
By defaut OUTPUT 1 and 2 are set to go On/Off by
using the Front Panel OUTPUT 1 and 2 Push-buttons
or by using the OUTPUT 1 and 2 Push-buttons on the
Remote Control. If it is desirable to have OUTPUT 1
and/or 2 always On regardless of the OUTPUT 1 and
2 Push-button settings, perform the following:
1. Press and hold in the INPUT Control to enter the
SETUP MODE. Refer to figure 2 on page 13.
2. Rotate the INPUT Control until “SETUP: Out-
puts, (Hold INPUT)” appears on the Information
Display. Refer to figure 21.
3. Press and hold in the INPUT Control until
“SETUP: OUTPUT 1, Switched” appears on the
Display. Refer to figure 22.
4. Rotate the VOLUME (ADJUST) Control to change
from the “Switched” setting to “Unswitched”.
Refer to figure 23.
5. In a similar manner, perform steps 3 and 4 to
change the OUTPUT 2 setting. Refer to figures 24
and 25 on the next page.
Setup, con’t
Figure 14
RENAME: BAL 1
>MEDIA <
Figure 13
RENAME: BAL 1
>MEDI <
Figure 20
To Next Page
Loading...
Need help?
General
