27
Rate (refer to figures 110 and 111 for PCM Signals).
Figures 112 and 113 indicate a Sampling Rate of 128
or 256 times the Sampling Rate of a CD Disc for the
incoming DSD Digital Audio Signal.
The Sampling Rate and the Bit Rate are determined
by the original recording, the Application Output
Format (when available) and the McIntosh-HD Control
Panel Settings.
Note: In general, when the original music is recorded
at a higher Sampling Rate, the result is usually
more detail in the music. However, this higher
rate results in consuming larger amounts of stor-
age space. The Sample Rate usually should be set
to match the Sample Rate of the music recording
being played back.
There are many third party Applications (besides
Applications like Windows Media Player) for steam-
ing music from the computer to McIntosh C2600 USB
Input. An example of just one of the available applica-
tions is “JRiver Media Center”.
How to Operate the C2600, con’t
Reset of Microprocessors
In the unlikely event the controls of the C2600 stop
functioning, the microprocessors can be reset by per-
forming the following:
1. Press and hold in the STANDBY/ON Push-button
until the LED above the STANDBY/ON Push-
button illumination is extinguished. Then release
the STANDBY/ON Push-button.
2. To switch the C2600 back On, press the STAND-
BY/ON Push-button.
Note: This can be performed with the C2600 On or in
the Standby Mode.
Figure 109
Figu re 110
To Next Page
Loading...
Need help?
General
