34
How to Operate the MA/MAC6700, con’t
METER BACKLIGHT
The MA/MAC6700 Front Panel Meter Illumination
may be switched On or Off by performing the follow-
ing:
1. Press the TRIM Push-button on the Remote Con-
trol until “METER BACKLIGHT, Lights: On”
appears on the Front Panel Display. Refer to figure
73.
2. Press TRIM LEVEL + / - Push-button to switch
Off the Meter Illumination. Refer to figure 74.
Figure 72
DIGITAL AUDIO
Display Info : Off
After approximately 5 seconds the Display returns to
indicate the Source Selection and Volume Level.
Notes: 1. For information on how the Front Panel
Display Brightness can change with the Meter
Illumination On/Off Setting, refer to page 33
Setup “Display Brightness”.
2. Meter Illumination of recent McIntosh Power
Amplifiers will also switch On/Off when con-
nected to the MA/MAC6700 via a power control
cable.
NOTE: The following TRIM Settings of “Tuner Control”
and “Tuner Text” are only available when a
McIntosh TM2 or TM3 Tuner Module is installed
in the MA6700 or MAC6700.
Figure 73
Lights: Off
Figure 50
TUNER CONTROL
The Tuning Mode of AM and FM Broadcast Stations
using the Front Panel VOLUME/TUNE Control may
be changed from the default setting of STATIONS
(Manual Tuning) by performing the following:
1. Press the TRIM Push-button on the Remote
Control until “TUNER CONTROL, STATIONS”
appears on the Front Panel Display. Refer to
figure 75.
2. Press TRIM LEVEL + / - Push-button to select
from the following choices:
A. STATIONS - Allows Manual Tuning of available
AM and FM broadcasts (the default
setting).
B. SEEK - Automatic Tuning of available AM
and FM broadcast.
C. PRESET - Selection of AM and FM stations
already entered into memory.
Refer to figures 76 and 77.
After approximately 5 seconds the Display returns to
indicate the Source Selection and Volume Level.
Figure 75
TUNER CONTROL
STATIONS
Figure 76
To Next Page
Loading...
