22
Power Output
130 watts into 8, 4 or 2 ohm loads is the minimum
sine wave continuous average power output per chan-
nel from 20Hz to 20,000Hz with both channels oper-
ating.
Total Harmonic Distortion
0.5% maximum harmonic distortion at any power
level from 250 milliwatts to rated power per channel
from 20Hz to 20,000Hz with both channels operat-
ing.
Intermodulation Distortion
0.5% maximum intermodulation distortion if instan-
taneous peak power output does not exceed twice the
output rating per channel with both channels operat-
ing, for any combination of frequencies from 20Hz to
20,000Hz.
Rated Power Band
20Hz to 20,000Hz
Frequency Response (at 1 watt)
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Hum and Noise (A-Weighted)
100dB below rated output
Damping Factor
Greater than 18
Output Load Impedance
2, 4 or 8 ohms
Specifications
Input Impedance
20K Ohms Unbalanced (RCA Phono Jacks)
40K Ohms Balanced (XLR Connectors)
Input Sensitivity (Switch Selectable)
2.5 volts for rated output
1.2 volts for rated output (1 volt for 100 watts output)
Tubes Compliment
8 KT88 or 6550 Output Tubes
4 12AX7A Input Tubes
2 12AT7 Driver Tubes
Power Requirement
100 Volts, 50/60Hz at 5.8 Amps
120 Volts, 50/60Hz at 4.8 Amps
230 Volts, 50/60Hz at 2.5 Amps
Note: Refer to the rear panel of the MC2000 for the
correct voltage.
Dimensions
17-3/4 inches (45.1cm) wide by 11 inches (27.9cm)
high. Depth behind front panel is 18-3/4 inches (47.6
cm). Handle clearance required in front of the mount-
ing panel is 1-5/8 inches (4.1 cm).
Finish
Stainless Steel Chassis with Titanium Gold Super
Mirror Finish, Black Transformer Enclosures, Black
Base, Glass Front Panel with gold plated Handles and
Knobs
Weight
Amplifier - 135 pounds (61.2 kg) net, 144 pounds
(65.3 kg) in shipping carton
Accessories - 18 pounds (8.2 kg) in shipping carton
Specifications
To Next Page
Loading...
