Need help?Do you have a question about the McIntosh MC2505 and is the answer not in the manual?
General| Total Harmonic Distortion | 0.25% |
|---|---|
| Input Sensitivity | 0.5V |
| Signal to Noise Ratio | 90dB |
| Damping Factor | 20 |
| Output Impedance | 4, 8, 16 ohms |
| Input Impedance | 250k ohms |
| Power Output | 50W per channel |
| Frequency Response | 20Hz to 20kHz |
Details the amplifier's low distortion guarantee, measured at full rated power for superior sound quality.
Explains the two-stage preamplifier with transistors and the use of AC/DC negative feedback.
Describes the series push-pull amplifier, selected transistors, and rigorous testing for reliability.
Discusses the trifilar autoformer for matching transistors to speaker impedances and achieving full power output.
Explains the circuit that prevents power output transistor failure due to output mismatch.
Lists key electrical parameters like power output, distortion, frequency range, and noise levels.
Instructions for attaching mounting brackets, making cutouts, and securing the unit with PANLOC.
Depicts the overall hookup diagram connecting Tuner, Preamplifier, and Speakers to the MC2505.
Instructions for connecting stereo inputs and detailed guide on speaker wiring by impedance.
A crucial warning against connecting a monophonic loudspeaker to both terminals to prevent damage.
To Next Page
