McIntosh MC207

22
Specifications
Specifications
Power Output
Minimum sine wave continuous average power output per
channel, all channels operating is:
200 watts into a 4 ohm or 8 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% for 4 or 8 ohm loads
Dynamic Headroom
1.7dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 100,000Hz
Sensitivity
1.0 Volt Balanced with a 4 ohm Loudspeaker
2.0 Volt Unbalanced with a 4 ohm Loudspeaker
1.4 Volt Balanced with a 8 ohm Loudspeaker
2.8 Volt Unbalanced with a 8 ohm Loudspeaker
A-Weighted Signal To Noise Ratio
89dB (112dB below rated output)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 4 or 8 ohm loads
Input Impedance
20,000 ohms Balanced
10,000 ohms Unbalanced
Wide Band Damping Factor
Greater than 60 at 4 ohms
Greater than 140 at 8 ohms
Power Requirements
100 Volts, 50/60Hz at 14.4 amps
110 Volts, 50/60Hz at 13.0 amps
120 Volts, 50/60Hz at 12.0 amps
220 Volts, 50/60Hz at 6.0 amps
230 Volts, 50/60Hz at 6.0 amps
240 Volts, 50/60Hz at 6.0 amps
Note: Refer to the rear panel of the MC207 for the correct
voltage.
Overall Dimensions
17-1/2 inches (44.45cm) W, 9-7/16 inches (23.97cm) H,
18-3/4 inches (47.63cm) D, including clearance for con-
nectors
Weight
83 pounds (37.6 kg) net, 116 pounds (52.6 kg) in shipping
carton