McIntosh MC2KW

MC2KW
OUTPUT
REPACKING INSTRUCTION
In the event it is necessary to repack the
equipment for shipment, the equipment must be
packed exactly as shown below. It is very impor-
tant that the four feet are attached to the bottom of
the equipment. This will ensure the proper equip-
ment location on the bottom foam pad. Failure to
do this will result in shipping damage. Also, to pro-
tect the finish of the glass and metal surfaces it is
advisable to place the MC2KW Output Module and
the MC2KW Power Modules into the orginal pro-
tective cotton blue bag before placing them into
the shipping carton.
Note: Unless instructed otherwise, please return the
McIntosh Custom Interconnect Cables along with the
MC2KW Power Amplifier.
Use the original shipping carton and interior
parts only if they are all in good serviceable condi-
Qty. Part No. Description
1 034104 Shipping carton bottom
1 034105 Shipping carton top
1 034356 Protective blue cloth cover
4 018445 Feet
3 034349 Foam ring
2 034349 Foam pad (top and bottom)
1 034341 Shipping carton for
interconnect cables
tion. If a shipping carton or any of the interior
part(s) are needed, please call or write Customer
Service Department of McIntosh Laboratory.
Please see the Part List for the correct part num-
bers.
Note: The McIntosh MC2KW Output Module and
MC2HW Power Module use the same shipping carton.
39