McIntosh MC602 LED

Audio Classics Ltd. McIntosh MC602 LED installation instructions 1-800-321-2834
Audio Classics, Ltd!
3501 Vestal Road!
Vestal, N.Y. 13850!
607-766-3501!
!
McIntosh MC602 LED!
Installation instructions!
!
Tools needed :!
Soft cloth or carpet!
#2 Philip's screwdriver!
1/4 inch nut driver!
5/16 inch nut driver!
!
Total assembly time about 1 hour!
!
Disconnect the AC Power mains before performing any service to the amplifier.!
!
Start with the amplifier upside down on a soft material. Remove the bottom panel.!

McIntosh MC602 LED Specifications

General

Number of Channels	2
Power Output per Channel	600W
Total Harmonic Distortion (THD)	0.005%
Damping Factor	>40
Frequency Response	+0, -0.25dB from 20Hz to 20, 000Hz
Input Impedance	20000 Ohms

Summary

McIntosh MC602 LED Installation

Preparation and Safety Guidelines

Lists required tools, assembly time, and crucial safety instruction to disconnect AC power.

Disconnect Internal Wiring Harnesses

Details locating and disconnecting four white wire connectors from the PC board to the front panel.

Remove Chassis and Panel Fasteners

Guides removing screws securing the front panel to the chassis and the rear shroud.

Remove Existing Meter Illumination Components

Instructs to remove the original meter illumination PC board and nomenclature illumination board.

Install New Meter Illumination Components

Details installing the new meter illumination assembly, LED board, and replacing meter housings/filters.

Final Assembly and Completion

Shows the finished panel appearance and advises on reassembly and enjoying the updated unit.