18
Specifications
Specifications
Power Output Stereo
Minimum sine wave continuous average power output per
channel, all channels operating is:
300 watts into 2 ohm load
300 watts into 4 ohm load
300 watts into 8 ohm load
Power Output Mono
Minimum sine wave continuous average power output per
channel, all channels operating is:
600 watts into 1 ohm load
600 watts into 2 ohm load
600 watts into 4 ohm load
Rated Power Band
20Hz to 20,000Hz
Total Harmonic Distortion
Maximum Total Harmonic Distortion at any power
level from 250 milliwatts to rated power output is:
0.005% for 2, 4 or 8 ohm loads (Stereo)
0.005% for 1, 2 or 4 ohm loads (Mono)
Dymanic Headroom
1dB
Frequency Response
+0, -0.25dB from 20Hz to 20,000Hz
+0, -3dB from 10Hz to 50,000Hz
Sensitivity
1Volt balanced or unbalanced inputs
A-Weighted Signal To Noise Ratio
114dB (2V)
Intermodulation Distortion
Maximum Intermodulation Distortion if instanta-
neous peak output per channel does not exceed
twice the rated output, for any combination of fre-
quencies from 20Hz to 20,000Hz, with all channels
operating is:
0.005% for 2, 4 or 8 ohm loads (Stereo)
0.005% for 1, 2 or 4 ohm loads (Mono)
Input Impedance
15,000 ohms balanced or unbalanced inputs
Power Requirements
12 Volts DC, 3.5 amps (idle) - 100 amps (600 watts)
Dimensions
26-7/8 inches (68.3cm) wide, 12-1/2 inches (31.75
cm) depth, 4-3/16 inches (10.64 cm) high
Weight
50.5 pounds (22.9 Kg) net, 58.5 pounds (26.5 Kg)
in shipping carton
www.freeservicemanuals.info
Digitized in Heiloo Netherland
To Next Page
Loading...
Need help?
General
