10
Installation
Installation
The MVP881BR can be placed upright on a table or
shelf, standing on its four feet. It also can be custom
installed in a piece of furniture or cabinet of your
choice. The four feet may be removed from the bot-
tom of the MVP881BR when it is custom installed as
outlined below. The four feet together with the mount-
ing screws should be retained for possible future use if
the MVP881BR is removed from the custom installa-
tion and used free standing. The required panel cutout,
ventilation cutout and unit dimensions are shown.
Always provide adequate ventilation for your MVP-
881BR. Cool operation ensures the longest possible
operating life for any electronic instrument. Do not
install the MVP881BR directly above a heat generat-
ing component such as a high powered amplifier. If
all the components are installed in a single cabinet, a
quiet running ventilation fan can be a definite asset in
maintaining all the system components at the coolest
possible operating temperature.
A custom cabinet installation should provide the fol-
lowing minimum spacing dimensions for cool opera-
tion.
Allow at least 6 inches (15.24cm) above the top, 2
inches (5.08cm) below the bottom, 3 inches (7.62cm)
behind the rear panel and 2 inch (5.08cm) on each
side of the Audio Video Player, so that airflow is not
obstructed. Do not block the ventilation holes on the
top and bottom cover; also do not block the rear
panel fan opening. Allow 1 inch (2.54 cm) in front
of the mounting panel for clearance. When the DISC
Tray is opened, the panel clearance required in front
of mounting panel is 6-3/4 inches (17.2cm). Be sure to
cut out a ventilation hole in the mounting shelf ac-
cording to the dimensions in the drawing.
To Next Page
Loading...