38
Purpose:
To Update the MVP881BR Firmware.
Requirements:
1. A functioning MVP881BR Audio/Video Player.
2. An Ethernet Connection between the MVP881BR
ETHERNET RJ45 connector (using a CAT5 or
CAT6 cable) to a Computer Network with router
providing Broadband Internet Access or directly
to a High Speed Modem with Broadband Internet
Access. Refer to page 12 for additional informa-
tion.
3. Internet access supporting DHCP protocol, check
with your Internet Service Provider.
Note: If your Internet Connection does not support
the DHCP protocol proceed to “Network Setup
Settings” before starting the Update Process.
4. An active Video Connection betweeen MVP-
881BR and a TV/Monitor.
5. An active AC Outlet.
Preparing for the Update Process:
With power Off to the MVP881BR, connect the ETH-
ERNET connector to the computer network/modem.
Note: Some Routers/Modems might require to be
reset after connection is made to the MVP-
881BR.
Perform the following steps:
1. Switch power On to the MVP881BR.
2. Remove any Disc or SD Memory Card from the
MVP881BR.
3. The Front Panel Information Display should indi-
cate “NO DISC” at this time. If the display indi-
cates “NO SD CARD” then press the Front Panel
SOURCE Push-button once and then wait until the
display indicates “NO DISC” before proceeding.
Firmware Update
Figure 82
OTHER SETUP
Firmware Update
Information
Power Saving
Auto Power Mode
Set other items.
a
►
▲
▼
HDMI
BD Data Utility
Initialize
LANGUAGE SETUP
Dialog
Subtitle
GUI Language
Disc Menus
Set the language used for playback dialogs, subtitles, and
menus.
a
HDMI
►
▲
▼
OTHER SETUP
Firmware Update
Information
Power Saving
Auto Power Mode
Update the firmware of the unit via the internet
►
▲
▼
BD Data Utility
Initialize
►
Check for Update
Start
Before starting the Update Process:
Before proceeding with the MVP881BR Firmware
Update, please keep in mind the following:
1. The Update process will erase the current firm-
ware inside the MVP881BR.
2. The MVP881BR will not function until a success-
ful Firmware Update is accomplished.
3. The Firmware Update Process will take a min-
mum of 20 minutes and depending on the speed of
the Internet Connection it could take upwards of
60 minutes or more.
4. DO NOT remove AC Power from the MVP881BR
during the Update Process.
5. DO NOT attempt to stop the Update Process once
it has started.
6. DO NOT operate the MVP881BR until the Update
Process is complete (the Front Panel Information
Display will indicate “NO DISC”).
Update Process:
1. Using the supplied MVP881BR Remote Control,
press the SETUP Push-button. The Front Panel
Information Display will indicate “SETUP”
and the TV/Monitor will now display the Setup
Graphics. Refer to figure 81.
2. Access the Other Icon and Menu by pressing the
Up or Down directional Push-buttons on the
supplied Remote Control. Refer to figure 82.
3. Press the Right Directional Push-button fol-
lowed by multiple presses of the Down Direc-
tional Push-button until the Firmware Update
Menu Item appears at the top of the menu in a
rectangular box. Refer to figure 83.
To Next Page
Loading...