28
How to Operate the MVP881BR
Your McIntosh MVP881BR has been configured
for default operating settings that will allow you to
immediately enjoy superb video and high fidelity
audio from a wide variety of discs. If you wish to
make changes to the default settings, a Setup feature
is provided to customize the operating settings using
On Screen Menus (refer to the Setup instructions in
this manual on page 18). Most operations that can be
performed with the Front Panel Push-buttons can also
be performed with the Remote Control.
Notes: 1. Some of the MVP881BR operating functions
such as Disc Languages, Video Angle or
Menu Language are active only if the function
is supported by data encoded on the disc.
2. Before powering On the MVP881BR, it is
important the supplied SD Memory Card is
Initialized and inserted into the Front Panel
SD Card Slot for proper operation when
playing back a Blu-Ray Disc. Refer to pages
5 and 18.
3. The MVP881BR Front Panel Slot needs an
Initialized SD Memory Card inserted only
when the Blu-ray DB Live Feature is acti-
vated.
Power On
The Red LED above the STANDBY/ON switch lights
to indicate the MVP881BR is in Standby mode. To
Switch ON the MVP881BR, press the STANDBY/
ON Push-button on the Front Panel or (Power On)
Push-button on the Remote Control. Refer to figures
30 and 36.
Note: When the MVP881BR is switched On it will
take approximately one minute for initializa-
tion of the internal circuitry to take place and
then the player is ready to begin operation.
Disc or SD Card Selection
The MVP881BR plays Optical Discs and SD Cards.
One can select between the two sources by press-
ing the SOURCE Push-button once. The Front Panel
Information Display indicates momentarily the source
selected when the
SOURCE Push-button
is pressed. Refer to
figures 31 and 32. The
Display will indicate
the MVP881BR is
loading the content
of the just selected
source. Refer to figure
33. When a source is
selected and no Disc/
SD Card is present the
display will indicate it.
Refer to figures 34 and
35.
How to Load a BD, DVD, SACD or CD Disc
1. Press the OPEN/CLOSE Push-button. The disc
tray will slide out allowing a disc to be loaded.
Refer to figures 30 and 36.
Note: When the player is in Standby Mode, the
MVP881BR Power will automatically Switch-
On when the OPEN/CLOSE Push-button is
pressed.
2. Press the OPEN/CLOSE Push-button and the disc
tray will close. If the tray contains a Blu-ray or
DVD disc, it will start to play without pressing the
PLAY Push-button. When a SACD or CD disc is
in the tray, the disc’s Table of Contents (number of
tracks and total playing time) will be indicated on
the Front Panel Alphanumeric Display. Press the
PLAY Push-button for playback of a CD.
Note: Do to the increase in Video/Audio resolution
of a Blu-ray Disc, it will take slightly longer to
read the increase in disc data before playback
will occur.
How to Play a BD or DVD Disc
With a disc already loaded into the MVP881BR, press
the (Play) Push-button on the Front Panel of the
MVP881BR or the Remote Control. Refer to figures
30 and 36.
Figure 30
Figure 31
To Next Page
Loading...