18
Your McIntosh MVP881BR has been factory config-
ured for default operating settings that will allow you
to immediately enjoy superb video and high fidelity
audio from a DVD-Video. It also reproduces DVD-
Audio, SACDs and CDs with unparalleled sonic pu-
rity. If you wish to make changes to the factory default
settings perform the following steps, if not proceed to
“How to Operate the MVP881BR” starting on
page 28.
Power
The Red LED above the STANDBY/ON switch lights
to indicate the MVP881BR is in Standby mode. To
Switch ON the MVP881BR, press the STANDBY/
ON Push-button on the Front Panel or the (Power)
Push-button on the Remote Control. Refer to figures 1
and 2.
Note: When the MVP881BR is switched On it will
take approximately one minute for initializa-
tion of the internal circuitry to take place and
the player is ready to begin operation.
Adjustments and Setting changes
All of the adjustments and settings are performed by
using the extensive On-Screen Menu System. The On-
Screen Menuing System is interactive. The ability to
change a menu item setting or have access to a menu
item setting (some may be “grayed out”) is dependent
on the operational state of the player and the choices
made in other menu items. Some menu choices require
more than one step to complete.
The active selection in a list of
options is indicated by a dot
located to the left side of the se-
lection, e.g. ●ON. When a disc
is playing in the MVP881BR
and the STOP Push-button is
pressed once (the disc play-
back is paused), some but not
all menu items are available
for change. To make all of the
menu items available for pos-
sible change, the playback of
the disc must be stopped which
requires two presses of the
STOP Push-button.
Note: The MVP881BR
must be connected
to a MONITOR/TV
either through an
A/V Control Center
or directly, for setup
and use. The Remote
Control supplied with
the McIntosh MVP-
881BR has several
Push-buttons labeled
differently than as
indicated on the On
Screen Menu, please refer to the following
Setup Instructions in this Owner’s Manual for
the correct Push-button.
Initialize the SD Memory Card
The following examples will illustrate how to initial-
ize the supplied SD Memory Card and any additional
SD Cards to be used with the MVP881BR. An initial-
ized SD Memory Card is required to be inserted into
the SD Front Panel Slot of the MVP881BR for use
during the BD Live Operation. To initialize the SD
Memory Card perform the following steps:
1. Press the SETUP Push-button on the Remote Con-
trol and the last selected Setup Menu Item will appear
on the Monitor/TV screen. The figure 3 illustration is
of the Language Setup Icon and Menu Options.
Note: There are eight Main Menu Icons located at the
left side of the On-Screen Setup Display. The
Icon Tabs are named Language Setup, HDMI
Setup, Video Setup, Audio Setup, Ratings Setup,
Network Setup, Display Setup and Other Setup.
2. Access the Other Icon and Menu by pressing the
Up or Down directional Push-buttons on the
supplied Remote Control. Refer to figure 4.
Introduction to the MVP881BR Setup Mode
Figure 1
Figure 2
Figure 3
To Next Page
Loading...