McIntosh MX120

30
Figure 14
repeat the level adjustment process until the test signal
volume levels of all the Loudspeakers are the same. The
Loudspeaker level cycling mode can be repeated as of-
ten as necessary.
8. Press the SELECT/OK Push-button to switch Off the
Automatic Loudspeaker Level Switching Mode. Refer
to figure 13.
9. Continue next to the INPUT SETUP. If you do not wish
to perform INPUT SETUP Adjustments at this time,
select MAIN MENU from the menu. The MAIN SYS-
TEM SETUP Menu will reappear on the Monitor/TV
screen and proceed to the next step.
10. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you may have
made, select YES to save those changes or NO not to
save them. The MX120 will then return to normal op-
eration. Refer to figure 7 on page 25.
Manual Loudspeaker Level Switching
11. Using the Left or Right directional push-buttons,
select MANUAL MODE from the SPEAKER LEVEL
On-Screen Menu, followed by pressing the SELECT/
OK Push-button to activate the Manual Loudspeaker
LEVEL Switching Mode. Refer to figure 14.
12. Adjust the volume of the Loudspeaker by pressing the
Left or Right directional push-buttons on the Re-
mote Control.
13. Using the Up or Down directional push-buttons,
select the next Loudspeaker and perform the level ad-
justing procedure. Continue this for each of the remain-
ing Loudspeakers. Repeat this as often as necessary un-
til you are satisfied that the volume levels of all the
Loudspeakers are the same.
14. Press the SELECT/OK Push-button to switch Off the
Manual Loudspeaker Level Switching Mode.
15. Continue next to the INPUT SETUP. If you do not wish
to perform INPUT SETUP Adjustments at this time, se-
lect MAIN MENU from the menu. The MAIN SYS-
TEM SETUP Menu will reappear on the Monitor/TV
screen and proceed to the next step.
16. Select EXIT from the MAIN SYSTEM SETUP Menu.
If you are satisfied with the changes that you may have
made, select YES to save those changes or NO not to
save them. The MX120 will then return to normal op-
eration. Refer to figure 7 on page 25.
Location Default Setting New Setting
Left Front 0dB
Center 0dB
Right Front 0dB
Right Surround 0dB
Right Back Sur 0dB
Left Back Sur 0dB
Left Surround 0dB
Subwoofer 0dB
Loudspeaker Levels
Figure 13
MENU: SPEAKER LEVEL
ÆAUTO MODE: SELECT TO STOP
LEFT FRONT 0
CENTER 0
RIGHT FRONT 0
RIGHT SURROUND 0
RIGHT BACK SURR 0
LEFT BACK SURR 0
LEFT SURROUND 0
SUBWOOFER 0
MAIN MENU
MENU: SPEAKER LEVEL
ÆMANUAL MODE: PRESS SELECT
LEFT FRONT 0
CENTER 0
RIGHT FRONT 0
RIGHT SURROUND 0
RIGHT BACK SURR 0
LEFT BACK SURR 0
LEFT SURROUND 0
SUBWOOFER 0
MAIN MENU