Remote Controller Operation Guide
1) Transmission Source
• The source where the signal is transmitted.
2) Signal Transmission Indication
• Blinks to confirm the last setting has been transmitted to
the unit.
3) “ON/OFF” Button
• Press once to start the unit.
• Press again to stop the unit.
4) Temperature Setting
• To set the desired room temperature, press the + or –
button to increase or decrease the set temperature.
• The temperature setting range is from 60ºF to 86ºF
(Optional setting 68ºF to 86ºF).
• Press both buttons simultaneously to toggle + and – from
ºC to ºF setting.
5) Operation Mode
• Press the MODE button to select the type of operating
mode.
• For cooling only unit, the available modes are: COOL,
DRY and FAN.
• For heat pump unit, the available modes are: AUTO,
COOL, DRY, FAN and HEAT.
6) Fan Speed Selection
• Press the
button continuously to toggle the fan speed
in the following order:
Low Med High Auto
• Stop pressing when the desired fan speed appears on
the display screen.
7) Turbo Function
• Press
for fast cooling or heating operation.
• The temperature will be increased internally if it is in HEAT mode, decreased if in COOL and DRY mode.
• Fan speed will be increased if it is not at maximum speed.
• The temperature and fan speed will resume to user setting if
is pressed again or after 20 minutes.
• Available under HEAT, COOL and DRY modes only.
8) ON Timer Setting
• Press the SET button will activate the on timer function.
• Set the desired on time by pressing the SET button continuously. If the timer is set to 7.30am, the air
conditioner will turn on at 7.30am sharp.
• Press the CLR button to cancel the on timer setting.
9) OFF Timer Setting
• Press the SET button will activate the off timer function.
• Set the desired of time by pressing the SET button continuously.
• Press the CLR button to cancel the off timer setting.
10) Automatic Air Swing (optional)
• Press the SWING button to activate the automatic air swing function.
• To distribute the air to a specific direction, press the SWING button and wait until the louver move to the
desired direction and press the button once again.
Page 24
IM-5WMF(SEER13)-0706
To Next Page
Loading...
Need help?
General
