OM-121 17
Group #4 Setup
Menu 8, “Group #4,” contains parameters that are used to set up the fourth multiple-unit control
group. Menu 8 is similar to menu 5; see “Group #1 Setup” above for more information.
RMC Schedule Assignment
Menu 9, “RMC Schedule,” allows you to assign one of the RMC Panel’s four schedules to each unit.
It is not necessary to assign an RMC schedule to a unit; for example, you could have an external
time clock start and stop a unit. For more information, see the “Scheduling” section in the
“Operator’s Guide” portion of this manual.
Schedule #1
Menu 10, “Schedule #1,” contains the internal scheduling parameters for the first RMC controller
schedule. This schedule, which is similar to the one in each unit controller, can be assigned to any
unit associated with the RMC Panel (see “RMC Schedule Assignment” above). For more
information, see the “Scheduling” section in the “Operator’s Guide” portion of this manual.
Schedule #2
Menu 11, “Schedule #2,” contains the internal scheduling parameters for the second RMC
controller schedule. Menu 11 is similar to menu 10; see “Schedule #1” above for more information.
Schedule #3
Menu 12, “Schedule #3,” contains the internal scheduling parameters for the third RMC controller
schedule. Menu 12 is similar to menu 10; see “Schedule #1” above for more information.
Schedule #4
Menu 13, “Schedule #4,” contains the internal scheduling parameters for the fourth RMC controller
schedule. Menu 13 is similar to menu 10; see “Schedule #1” above for more information.
Holiday Date
Menu 14, “Holiday Date,” allows you to schedule 14 holiday dates. Each date can be assigned a
duration from 1 to 31 days. On each day of the holiday period, the holiday schedules entered under
menus 10, 11, 12, and 13 are used. For more information, see the “Scheduling” section in the
“Operator’s Guide” portion of this manual.
Time and Date
Menu 15, “Time/Date,” allows you to adjust the current time, day, and date. You can also set up the
controller for daylight-saving time. For more information, see the “Scheduling” section in the
“Operator’s Guide” portion of this manual.
Service
Menu 16, “Service,” contains controller setup and service related items. For more information, see
the following “RMC and Unit Controller Setup” section. The last item, “IDENT=,” displays the
RMC controller’s program code.
To Next Page
Loading...