McQuay MicroTech RMC-E01A - Introduction; Table 1. Microtech Unit Controller Installation Literature; Table 2. Microtech Unit Controller Operation Literature

OM-121 5
Introduction
This manual provides information about the MicroTech

Remote Monitoring and Control (RMC)
Panel for McQuay RoofPak

applied rooftop systems and McQuay self-contained air conditioning
(SCAC) systems. It specifically describes the RMC Panel’s features, sequences of operation, and
programmable options. It also includes information on how to use the keypad/display to enter and
display data.
For information on MicroTech components, field wiring options and requirements, network
commissioning procedures, and service procedures, refer to Bulletin No. IM 444, MicroTech
Remote Monitoring and Control Panel. For specific information about the MicroTech unit
controllers, refer to the appropriate MicroTech unit controller installation or operation manual (see
Table 1 and Table 2).
Table 1. MicroTech Unit Controller Installation Literature
Unit Type Installation & Maintenance Data Bulletin Number
Applied Rooftop IM 483
SCAC IM 608
Table 2. MicroTech Unit Controller Operation Literature
Unit Type Unit Control Configuration Operation Manual Bulletin Number
Applied Rooftop Variable Air Volume OM 108
Constant Air Volume, Zone Temperature Control OM 109
Constant Air Volume, Discharge Temperature Control OM 110
SCAC Variable Air Volume & Constant Air Volume, Discharge
Temperature Control
OM 123
Constant Air Volume, Zone Temperature Control OM 124
!
WARNING
Electric shock hazard.
Can cause personal injury or equipment damage.
This equipment must be properly grounded. Connections and service to the MicroTech control
panel must be performed only by personnel that are knowledgeable in the operation of the
equipment being controlled.
NOTICE
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with this instruction manual, may cause interference to radio
communications. It has been tested and found to comply with the limits for a Class A digital
device, pursuant to part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his or her own
expense. McQuay International disclaims any liability resulting from any interference or
for the correction thereof.