72 Product Manual WHR-2
1.05 DELIVERY AND HANDLING
A. Chillers shall be delivered to the job site completely assembled and charged with
refrigerant and oil by the manufacturer.
B. Comply with the manufacturers instructions for rigging and handling equipment.
1.06 WARRANTY
The equipment manufacturer’s warranty shall be for a period of one year from date of
equipment start and acceptance but not more than 18 months from shipment. The
warranty shall cover defective material and workmanship within the above period,
excluding refrigerant.
PART 2--PRODUCTS
2.01 ACCEPTABLE MANUFACTURERS
A. McQuay International
B. (Approved Equal)
2.02 UNIT DESCRIPTION
Provide and install as shown on the plans factory assembled, factory charged, and factory
run tested, water-cooled reciprocating compressor packaged chillers in the quantity
specified. Each chiller shall consist of hermetic reciprocating compressor, direct expansion
evaporator, water-cooled condenser, control system and all components necessary for
safe and controlled unit operation.
2.03 DESIGN REQUIREMENTS
A. General: Provide a complete reciprocation packaged chiller as specified herein and
as shown on the drawings. The unit shall be in accordance with the standards
referenced in section 1.02 and any local codes in effect.
B. Performance: Refer to the schedule of performance on the drawings. Performance
shall be in accordance with applicable ARI Standard.
C. Acoustics: Sound pressure levels for the unit shall not exceed the following
specified levels. The manufacturer shall provide the necessary sound treatment
to meet these levels if required. Sound data shall be provided with the quotation.
Test shall be in accordance with ARI Standard 575.
Octave Band
63 125 250 500 1000 2000 4000 8000 dBA
____ ____ ____ ____ ____ ____ ____ ____ ____
To Next Page
Loading...
Need help?
General
