www.marketdirect.com.au Ph: 1300 494 494
46
MkII Diesel Heater
Vin# LC003508 onwards
Operation
1. Control Knob
2. Heating (power on) mode button
3. Heating (power on) indication light
4. Constant temperature indication light
5. Constant temperature mode button
6. Ventilation mode button
7. Ventilation indicating light
Heater Control Switch
Power on
Press the heating (2 power on) button, the heating (constant power) will ash for 0.3S. The heater will begin the start
stage. The controller will run heating the program according to the temperature control target set by the control
knob. In the start stage, the time delay from switch-on to fuel supply to the fuel pump is around 65 seconds.
Temperature Control
When the combustor is ignited and running, you can turn the control knob according to the arc mark around the
control switch (1) to control the temperature.
Ventilation mode
You can only enter the ventilation mode when you press the ventilation mode key to start the heater. The ventilation
indicating light turns green after pressing ventilation button. Heater can only circulate air without any heating. The
fan speed can be continuously regulated with the control knob.
Shutdown
To shut down the unit, press the button indicative of the current mode of operation. If the fuel pump is at work
before the heater is turned off, the pump will shut down immediately, but the fan will continue to run for
180 seconds.
*DO NOT TURN OFF MAIN SWITCH ON PANEL UNTIL THE UNIT HAS COMPLETED ITS SHUTDOWN PROCESS.
To Next Page
Loading...
