EasyManua.ls Logo

MDC XT10E 2021 - Page 75

MDC XT10E 2021
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
www.marketdirect.com.au Ph: 1300 494 494
71
36 MONTHS / 30,000KM SERVICE CHECKED
Chassis and Suspension
Hitch • Inspect for damage and lubricate. Check bolt Torque to 76Nm.
Jockey Wheel • Inspect for condition and operation.
Breakaway • Check for correct operation.
• Inspect lanyard and clip.
Drawbar • Inspect wiring grommets and general condition.
Suspension • Torque bolts to 190Nm.
• Grease bushes and check for play.
• Check torque on suspension hanger bolts (190nm)
• Check retaining chain shackles tight.
• Inspect shock absorber for condition.
• Inspect shock absorber bushes.
Brakes • Inspect and adjust. Check lining thickness and drum wear.
Wheel bearings Replace bearings, seals and lubricate. Check stub axle condition and
wear. Replace split pin.
Wheel Nuts Inspect condition and torque to 125Nm (12mm studs)
(140Nm 14mm studs alloy rims) (200Nm 14mm studs steel rims).
Tyres • Inspect for abnormal wear, damage, and pressure.
• Check manufacturing date less than 5 years.
• Check sidewalls for perishing and damage.
12 volt electrical
Lights • Check all trailer lights are functioning.
• Check plug pins have gap.
• Check for corrosion.
Battery • Check terminals and voltage at full charge.
• Check batteries are secure in cradles.
Charging • Check battery charger settings are correct.
• Check DC to DC charger settings are correct.
Solar Panels • Check panels are free of damage.
• Inspect sealants on cable penetrations and junction boxes.
Cables • Inspect cables under body for damage to conduits.
• Inspect cable glands and sealants on penetrations through oor.
240 volt Electrical
RCD Unit • Check operation of RCD via test button.
Mains Input • Inspect mains input plug and cover are free of damage.
Earthing • Carry out resistance check.
Caravan Body
Hatches & Doors • Check and lubricate locks.
Seals Check condition and correct latch/lock adjustment for correct
30-50% compression.

Table of Contents

Related product manuals