Why has condensation returned after using my Meaco 20L Dehumidifier?
If condensation has returned to your windows after they were clear, it may be because the outside air temperature has dropped, making the windows colder. To address this, use your Meaco Dehumidifier on Maximum setting and run it 24 hours a day.
Why can't my Meaco 20L remove condensation from windows?
If you cannot remove condensation from your windows, even in Maximum mode on your Meaco Dehumidifier, it's likely that the surface temperature of the windows is too low for the dehumidifier to prevent condensation. This is common with single-glazed windows, especially when the outside air temperature drops below freezing. Continue running the dehumidifier on Maximum 24 hours a day, and the condensation should clear when the outside air temperature increases.
What does it mean when the drying light flashes on my Meaco 20L Dehumidifier?
If the drying light on your Meaco Dehumidifier is flashing, it means the ambient temperature is either below zero or above 40°C. If the temperature is within these limits, contact Meaco, as the NTC may be faulty.
What does the flashing defrost indicator on my Meaco 20L mean?
If the defrost indicator is flashing on your Meaco Dehumidifier, it indicates that the temperature is above 40°C. If the temperature is not high, contact Meaco, as you may have an NTC fault.
Explains the control panel's indicator lights and operational modes like Laundry, Normal, and Maximum.
Explains the basic operation of a compressor-based dehumidifier and common issues like condensation.
Discusses where to place the dehumidifier and its effectiveness in addressing moisture and mould.
Provides guidance on setting up the dehumidifier, positioning it correctly, and using its functions.
Details how water is collected, the amount collected, and important safety precautions during operation.
Explains how to connect a drainage hose for continuous water removal and its proper setup.
Lists common issues like unit not working, not dehumidifying, noise, and drying light flashes with their causes and solutions.
General| Power Consumption | 255W |
|---|---|
| Type | Compressor |
| Refrigerant | R290 |
| Humidity Control | Yes |
| Continuous Drainage | Yes |
| Air Flow | 160 m³/h |
| Capacity | 20L |
| Extraction Rate | 20L/day |
| Filter Type | Dust Filter |
| Suitable for | Homes |
| Operating Temperatures | 5°C to 35°C |
To Next Page