To Next Page
A
Alexis RossSep 23, 2025
What to do if EEPROM is damaged on Measuretek EHC-C-3?
- DDavid HessSep 23, 2025
If the EEPROM is damaged on your Measuretek Scales, service is required to replace the main EEPROM IC chip.
What to do if EEPROM is damaged on Measuretek EHC-C-3?
If the EEPROM is damaged on your Measuretek Scales, service is required to replace the main EEPROM IC chip.
What does Err01 mean on my Measuretek Scales?
If the Measuretek Scales display shows 'Err01', it means the weight reading exceeds the overload limit or cannot be displayed in the current unit. Reduce the load on the scale until the weight value is displayed, or use an alternate unit of measure.
What to do if my Measuretek EHC-C-3 Scales show Err04?
If your Measuretek Scales display shows 'Err04', the weight exceeds the Power On Zero limit (+15%) or the ZERO key range (+5%). Ensure the scale platform is empty, power off the scale, and then power it on again. You may also need to perform a zero calibration.
What to do if my Measuretek EHC-C-3 show Err03?
If your Measuretek Scales display shows 'Err03', it means the weight reading is below the minimum load limit. Install the platform on the scale and perform a zero calibration.
What does Err05 mean on my Measuretek EHC-C-3 Scales?
If your Measuretek Scales display shows 'Err05', it means the weight is below the Power On Zero limit (-15%) or below the ZERO key range (-5%). Install the platform on the scale and perform a zero calibration.
What to do if load cell wires are incorrectly connected on Measuretek Scales?
If the load cell wires to the indicator are incorrectly connected, shorted, or open, or if the ADC or load cell are damaged, make sure the wires are correctly connected. Service is required to replace the load cell or ADC chip.
How to reset setup parameters on Measuretek Scales?
If the setup parameters on your Measuretek Scales are not set, not correctly set, or have been lost, you should reset the parameters and perform a calibration.
What to do if weight exceeds Power On Zero limit on Measuretek EHC-C-3?
If the weight exceeds the Power On Zero limit (+15%) or is over the ZERO key range (+5%) on your Measuretek Scales, ensure the scale platform is empty. Power off the scale and then power it on again. Perform a zero calibration.
What does Err30 mean on my Measuretek EHC-C-3?
If your Measuretek Scales display shows 'Err30', the load cell wires to the indicator are incorrectly connected, shorted, or open, or the ADC or load cell is damaged. Ensure the wires are correctly connected. Service is required to replace the load cell or ADC chip.
What does Err40 mean on my Measuretek Scales?
If your Measuretek Scales display shows 'Err40', the data memory is not set, not correctly set, or the set data has been lost. Reset the data memory for the address you are attempting to recall.
General| Capacity | 3 kg |
|---|---|
| Readability | 0.1 g |
| Tare Range | Full capacity |
| Calibration | External Calibration |
| Units of Measurement | g, oz, lb, ozt, dwt |
| Interface | RS-232 |
| Auto-off | Yes |
| Power Supply | AC adapter or 4 AA batteries |
