DC30D GENSET CONTROLLER USER MANUAL
14
"ALARM" lights on, without stopping the engine, and displays " Istant warn " on the
LCD screen.
Oil Pressure Sensor Opened Warning
When the safety delay is over, the controller detects that the Oil Pressure sensor is
disconnected, Then start warning delay and the duration (Normal alarm delay) have
not returned to normal, the warning of the Oil Pressure sensor opened is reported.
"ALARM" lights on, without stopping the engine, and displays "OP sensor open " on
the LCD screen.
Temperature Sensor Opened Warning
When the safety delay is over, the controller detects that the Temperature sensor is
disconnected, Then start warning delay and the duration (Normal alarm delay) have
not returned to normal, the warning of the Temperature sensor opened is reported.
"ALARM" lights on, without stopping the engine, and displays "WT sensor open " on
the LCD screen.
Fuel Level Sensor Opened Warning
When the safety delay is over, the controller detects that the Fuel level sensor is
disconnected, Then start warning delay and the duration (Normal alarm delay) have
not returned to normal, the warning of the fuel level sensor opened is reported.
"ALARM" lights on, without stopping the engine, and displays " FL sensor open " on
the LCD screen.
Maintenance expiration warning
When the action after the primary maintenance expired set as “warning”, When the
countdown to maintenance is detected as "0", Then start warning delay and the
duration (Normal alarm delay) have not returned to normal, the warning of
Maintenance expiration is reported. "ALARM" lights on, without stopping the engine,
and displays "Maintain end" on the LCD screen.
High Battery Voltage Warning
When the controller detects that the battery voltage is higher than “Over battery
voltage warning”, Then start warning delay and the duration (Normal alarm delay)
have not returned to normal, the warning of High Battery Voltage is reported.
"ALARM" lights on, without stopping the engine, and displays " Over BATT volt " on
the LCD screen.
Under Battery Voltage Warning
When the controller detects that the battery voltage is lower than “Under battery
voltage warning”, Then start warning delay and the duration (Normal alarm delay)
have not returned to normal, the warning of Under Battery Voltage is reported.
"ALARM" lights on, without stopping the engine, and displays " Under BATT volt "
on the LCD screen.
Starting fault
Fail to Start
To Next Page
