Page 18 Micro 19-XD - Operator’s Manual
July 2020
Operating Instructions & Functions Test
DO NOT operate this machine until you have read and understood this manual, have performed the
Workplace Inspection, Pre-Start Inspection and Routine Maintenance, and have completed all the test
operations detailed in the Operating Instructions section.
This section provides instructions and tests for each function of machine operation. Follow all safety
rules and instructions. The operator must conduct inspections and a Functions Test of the machine
before each work shift to check that all machine systems are working properly.
Test the machine on a firm level surface with no debris, drop-offs, potholes or overhead obstructions.
Perform each step outlined in this section.
This machine shall only be operated by trained and authorized personnel. If multiple operators use
this machine, all must be trained, qualified and authorized to use it. New operators must perform a
Pre-Start Inspection and Functions Test prior to operating the machine.
Operators must comply with all employer and job site rules and governmental regulations regarding
the use of personal protective equipment.
DO NOT use a machine that is malfunctioning. If any function does not perform as described, tag the
machine and remove for repair by a qualified service technician. After repairs are completed, a Pre-
Start Inspection and Functions Test must be performed before using the machine.
Check the area above and around the machine for obstructions and
electrical power lines before operating the machine. The machine must
have space to allow full elevation of platform.
Prestart
Perform Prestart Inspection (see page 31).
Check Emergency Stop Switches at the platform controls – turn clockwise to
reset.
Check Main Power/Lower Emergency Stop Switch. Must be in ON position.
ART_5231
ON
OFF
Main Power/
Lower Emergency
Stop Switch
Operating Instructions & Functions Test
Section 9 - Operating Instructions and Function Tests
To Next Page
Loading...
