Page 27 Micro 19-XD - Operator’s Manual
July 2020
Battery Charging
The charger surface can get hot while operating. Contact with the skin or
surrounding materials should be avoided.
To reduce the risk of an electric shock, connect only to a properly
grounded single-phase (3 wire) outlet.
Do not use an external charger or booster battery.
Charge the battery in a well-ventilated area.
Use proper AC input voltage for charging as indicated on the machine.
Use only MEC authorized batteries and chargers.
IMPORTANT: Be sure to disconnect the charger from the outlet before attempting to operate the
unit.
The charger will indicate the status of the charge cycle.
Battery Charging
Section 10 - Battery Charging
To Next Page
Loading...
