Page 12 Micro 26 - Service & Parts Manual
April 2019
Emergency Systems and Procedures
IF THE CONTROL SYSTEM FAILS WHILE THE PLATFORM IS ELEVATED,
USE THE EMERGENCY LOWERING PROCEDURE TO SAFELY LOWER
THE PLATFORM.
DO NOT CLIMB DOWN THE ELEVATING ASSEMBLY OR EXIT THE
PLATFORM.
Emergency Stops
The machine is equipped with an EMERGENCY STOP switch at the base
controls and the platform control box.
Press the EMERGENCY STOP switch at any time to stop all machine
functions.
Turn switch clockwise to reset.
Either switch will stop all machine functions.
Both switches must be reset or machine will not operate.
•
•
•
•
Emergency Lowering
ART_5016
Emergency
Lowering
Handle
The Emergency Lowering System is used to lower the platform in case of
power failure.
To lower the platform, pull the Emergency Lowering Knob, located near the
Base Control panel.
Section 8 - Emergency Systems and Procedures
Emergency Systems and Procedures
To Next Page
Loading...
