Page 13 Micro 26 - Service & Parts Manual
April 2019
Transporting and Lifting Instructions
Safety Information
This section is provided for reference and does not supersede any
government or company policy regarding the loading, transport or lifting
of MEC machinery.
Truck drivers are responsible for loading and securing machines, and
should be properly trained and authorized to operate MEC machinery.
Drivers are also responsible for selecting the correct and appropriate
trailer according to government regulations and company policy. Drivers
must ensure that the vehicle and chains are strong enough to hold the
weight of the machine (see the serial number plate for machine weight).
While loading and unloading, the transport vehicle must be parked on a
level surface and secured to prevent rolling.
Free-wheel configuration for Winching or Towing
RUNAWAY HAZARD!
After releasing the brakes there is nothing to stop machine travel.
Machine will roll freely on slopes.
ALWAYS chock the wheels before manually releasing the brakes.
The machine can be winched or towed short distances at speeds not to exceed 5 mph.
Before towing or winching the machine, it is necessary to release the brakes. Reset the brakes after
towing or winching.
Disengage Brakes before Towing or Winching
Push Down
& Hold
1
Turn to
Ground
2
ART_5029
Chock the wheels.
Turn the Key Switch to the OFF position.
Pull or turn the red Emergency Stop button clockwise to the on
position at both the ground and platform controls.
At the Ground Controls panel, press and hold the Lift/Lower
Switch to the DOWN position, then turn on the Key Switch to the
GROUND position.
Hold the Lift/Lower Switch in this position until a continuous alarm
sounds, signalling that the brake has been released.
1.
2.
3.
4.
5.
Resetting Brakes
Press the Emergency Stop Switch or turn the Key Switch to the OFF position to reset the brake.
Section 9 - Transporting and Lifting Instructions
Transporting and Lifting Instructions
To Next Page
Loading...
