Mec MME25 - Operation from Ground with Controller

Page 26 Mast Series - Operator’s Manual
April 2021Section 8 - Operating Instructions
Note: Slope rating is subject to ground conditions and adequate traction.
Press the drive speed button to the fast drive speed mode.
To determine the slope grade
Measure the slope with a digital inclinometer OR use the following procedure.
You will need:
Carpenter’s level
Straight piece of wood, at least 3.3 ft / 1m long
Tape measure
Lay the piece of wood on the slope.
At the downhill end, lay the level on the top edge of the piece of wood and lift the end until the piece
of wood is level.
While holding the piece of wood level, measure the distance from the bottom of the piece of wood to
the ground.
Divide the tape measure distance (rise) by the length of the piece of wood (run) and multiply by 100.
Example:
Run = 11.8 ft
Rise = 0.98 ft
0.98 ÷ 11.8 = 0.083 x 100 = 8.3%
•
•
•
ART_4983
If the slope exceeds the maximum slope or side slope rating, the machine must be winched or
transported up or down the slope. See Transport and Lifting section.
Operation from Ground with Controller
Maintain safe distances between operator, machine and fixed objects.
Be aware of the direction the machine will travel when using the controller.
Battery Level Indicator
Use the LED readout screen to determine the battery level.
ART_4984
FULL LOW
To Extend and Retract Platform
Pull and turn the platform lock pin handle on the extension deck.
Push the platform extension guardrail to extend the platform.
Turn the handle and push the platform lock pin to the socket on the extension deck.
Reverse the above steps to retract platform.
Note: Do not stand on the platform extension while trying to extend and retract it.
•
•
•
1.
2.
3.
4.