Mec MME25 - Section 3 - Specifications; Specifications

Page 4 Mast Series - Operator’s Manual
April 2021
Specifications
MME20 MME25
Height, Working Maximum*
Indoor 26 ft 8.0 m 31 ft 9.5 m
Outdoor 22 ft 6.8 m 26 ft 8.0 m
Height, Platform Maximum
Indoor 20 ft 6.0 m 25 ft 7.5 m
Outdoor 16 ft 4.8 m 20 ft 6.0 m
Height - Stowed 78.35 in 1.99 m 78.35 in 1.99 m
Width 30 in 0.76 m 31.50 in 0.80 m
Length 54.7 in 1.39 m 56.7 in 1.44 m
Platform Dimensions - Retracted
Platform Length × Width
29.5×28.5 in 0.75×0.72 m 29.5×28.5 in 0.75×0.72 m
Platform Dimensions - Extended
Platform Length × Width
50.5×28.5 in 1.28×0.72 m 50.5×28.5 in 1.28×0.72 m
Maximum Load Capacity 350 lbs 159 kg 350 lbs 159 kg
Rated Persons
Indoor 1 1
Outdoor 1 1
Maximum Wind Speed
Indoor 0 mph 0 m/s 0 mph 0 m/s
Outdoor 28 mph 12.5 m/s 28 mph 12.5 m/s
Wheelbase 44 in 1.12 m 44 in 1.12 m
Turning Radius
Outside 61 in 1.55 m 62.2 in 1.58 m
Inside 0 in 0 m 0 in 0 m
Ground Clearance 2.36 in 6 cm 2.36 in 6 cm
Ground clearance
Pothole guards deployed
0.55 in 1.4 cm 0.55 in 1.4 cm
Weight ** 2,740 lbs 1,243 kg 3,310 lbs 1,501 kg
Power Source 2×12V 115Ah 2×12V 115Ah
Controls Proportional Proportional
AC Outlet In Platform Standard Standard
Maximum Hydraulic Pressure (Functions) 2,610 psi 180 bar 2,610 psi 180 bar
System Voltage 24V 24V
Driving Wheels 12.7×3.9 in 323×100 mm 12.7×3.9 in 323×100 mm
Airborne Noise Emissions <70 dB; Maximum sound level at normal operating workstations (A-weighted)
Vibration Value Does Not Exceed 2.5 m/s
2
2.5 m/s
2
Maximum Slope Rating
Stowed Position - Fore/Aft
25% 25%
Maximum Side Slope Rating
Stowed position
10% 10%
Note: Slope rating is subject to ground conditions and adequate traction.
Maximum Working Slope 1.5° side-to-side, 3.0° in-line
Drive speeds
Stowed, Maximum 2.5 mph 4.0 km/h 2.5 mph 4.0 km/h
Platform Raised, Maximum 0.7 mph 1.1 km/h 0.7 mph 1.1 km/h
Floor Loading Information
Tire Load, Maximum 937 lbs 425 kg 1,102 lbs 500 kg
Tire Contact Pressure - Max Load 115 psi / 8.1 kg/cm
2
793.8 k Pa 149 psi / 10.5 kg/cm
2
1028.0 kPa
Occupied Floor Pressure 235 psf / 1,150 kg/m
2
11.27 kPa 267 psf / 1,304 kg/m
2
12.8 kPa
Meets requirements of ANSI 92.20-2020 and CSA B354.6-2019.
Floor loading information is approximate and does not incorporate different option configurations.
It should be used only with adequate safety factors.
*Working Height adds 6 feet (2 m) to platform height.
**Weight may increase with certain options.
Section 3 - Specifications
Specifications