Page 24 Mast Series - Operator’s Manual
April 2021
Operating Instructions
Do Not Operate Unless:
You learn and practice the principles of safe machine operation contained in this operator’s manual.
Avoid hazardous situations.
Always perform a pre-operation inspection.
Inspect the workplace.
Always perform function tests prior to use.
Only use the machine as it was intended.
Fundamentals
This machine is a self-propelled hydraulic lift equipped with a work platform on the vertical
mechanism. Vibrations emitted by these machines are not hazardous to an operator in the work
platform. The machine can be used to position personnel with their tools and supplies at position
above ground level and can be used to reach work areas located above and over machinery or
equipment.
The Operating Instructions section provides instructions for each aspect of machine operation.
It is the operator’s responsibility to follow all the safety rules and instructions in the operator’s, safety
and responsibilities manuals.
Using the machine for anything other than lifting personnel, along with their tools and materials, to an
aerial work site is unsafe and dangerous.
Only trained and authorized personnel should be permitted to operate a machine. If more than one
operator is expected to use a machine at different times in the same work shift, they must all be
qualified operators and are all expected to follow all safety rules and instructions in the operator’s,
safety and responsibilities manuals. That means every new operator should perform a pre-operation
inspection, function tests, and a workplace inspection before using the machine.
Emergency Stop
Push in the red Emergency Stop button to the off position at the ground controls or the platform
controls to stop all machine functions.
Repair any function that operates when either red Emergency Stop button is pushed in.
Emergency Lowering
Pull the emergency lowering knob to lower the platform.
Operation from Ground
Turn the key switch to ground control.
Pull out both ground and platform red Emergency Stop buttons to the on position.
Be sure the battery pack is connected before operating the machine.
To Position Platform
Move the up/down switch according to the markings on the control panel.
1.
2.
3.
4.
5.
1.
1.
2.
3.
1.
Operating Instructions
Section 8 - Operating Instructions
To Next Page
Loading...
