24
Playing Voices
Editing Voices
The voice edit function enables you to create your own voices by editing parameters of existing voices. You can save up
to 512 User Voices and recall them from the USER voice tab.
Select a voice to edit. Press the “Edit” button on the Voice Selection display to call up the Voice Edit menu.
Editable Parameters
The parameters you can edit are categorized into four tabs at the top of the menu. Press on one of the tabs to edit that
parameter.
Basic Tab
This menu contains “Basic”, “Envelope”, and “Vibrato” parameters .
Basic Default Volume Change the default volume of the current voice. 0~127
Cutoff Adjust the lter cutoff of the voice.
As the value is turned higher, the voice becomes brighter.
0~127
Resonance Adjust the lter resonance of the voice.
As the value is turned lower, the resonance effect becomes stronger.
0~127
Envelope Attack Determines the time it takes for a sound to reach maximum volume after the key is
pressed and sound begins.
As the value is turned lower, the sound begins faster.
0~127
Decay Determines the time it takes for a sound to reach its sustain level volume after the
attack.
As the value is turned lower, the sound decays faster.
0~127
Release Determines the time from when you release the key until the sound decays to
silence.
As the value turned lower, the sound disappears faster.
0~127
Vibrato Rate Determines how fast one vibrato effect cycle is played.
As the value is turned higher, the vibrato speed becomes faster.
0~127
Depth Determines the strength of the vibrato effect.
As the value is turned higher, the effect becomes stronger.
0~127
Delay Determines how quickly the Vibrato effect starts after the sound begins.
As the value is turned higher, the vibrato starts later.
0~127
AKX10_OM05_EN_190816.indd 24 2019/8/16 13:37
To Next Page
Loading...
Need help?
General
