RX8000 Integrated Receiver/Decoders
1553-FGB 101 759 Uen K
www.mediakind.com
The diagram above shows the general CA status of the unit, this provides:
•
Index – The current list number of the CA service being
selected for descrambling (this is just an incrementing
number).
• Service ID – The service ID of the service to be descrambled
(this is taken from the PAT).
• Status – This is the current CA status of the service. This is
more detailed than the CA Status message reported from the
main Status page.
The table below lists all the possible CA Status messages and their meaning. The first column lists the
CA Status messages that are displayed in the CA Service Status table described above. The second
column lists the equivalent CA Status message reported from the main Status page shown in Figure
3-16. The third column describes meaning of the CA Status message.
Table 3-10 Current Status Messages
CA page > CA Service
Status > Status
Status page > CA Status Description
NO SERVICE NO SERVICE
No Transport Stream has been
detected and no service list can be
built.
SERVICE CLEAR SERVICE CLEAR
Service components for the selected
service are not scrambled.
SERVICE AUTHORIZED SERVICE AUTHORIZED The receiver is authorized for
descrambling the selected service.
Descrambling is successfully being
applied.
CAM PRESENT
(ATTEMPTING
DECRYPTION
SELECTED PIDS ONLY)
SERVICE AUTHORIZED
(SELECTED PIDS ONLY)
The CA Module (DVB-CI) is detected
and configured for descrambling
selected service component PIDs only.
CAM PRESENT
(ATTEMPTING
DECRYPTION)
CAM PRESENT
(ATTEMPTING
DECRYPTION)
The CA Module (DVB-CI) is detected
and configured for descrambling. No
errors are detected.
SERVICE NOT
AUTHORIZED
CONDITIONAL ACCESS
ERROR
The receiver is not authorized for
descrambling the selected service.
CAM PRESENT NOT
DECRYPTING (MAX
COMPONENTS/SERV)
CONDITIONAL ACCESS
ERROR
The CA Module (DVB-CI) is detected
however the number of service
components selected for descrambling
exceed that configured for each
service for the CA Module.
CAM PRESENT NOT
DECRYPTING (PID
FULL)
CONDITIONAL ACCESS
ERROR
The CA Module (DVB-CI) is detected
however the number of service
components selected for descrambling
exceed that configured for the CA
Module.
CAM PRESENT NOT
DECRYPTING (SERVICE
FULL)
CONDITIONAL ACCESS
ERROR
The CA Module (DVB-CI) is detected
however the number of services
selected for descrambling exceed that
configured for the CA Module.
CAM PRESENT (NOT
DECRYPTING)
CONDITIONAL ACCESS
ERROR
The CA Module (DVB-CI) is detected
however the service has not been set
up for descrambling.
To Next Page
