RX8000 Integrated Receiver/Decoders
1553-FGB 101 759 Uen K
www.mediakind.com
C.2.13. Seamless Protection Switching Alarm Identifiers
Table C.12 Seamless Protection Switching Alarm Identifiers
Name Identifier Description
Seamless Switching sync failure 1150
If seamless switching mode fails to sync between the
two input streams when Seamless Protection mode is
enabled
RTP Packet Drop Ratio 1 1151 The ratio of RTP Packet sequence numbers missing over
the number of RTP Packets entering the Seamless
Protection block on interface Port 1 has exceeded the
user defined alarm threshold.
The ratio is continuously evaluated over the preceding
30 seconds.
RTP Packet Drop Ratio 2 1152 The ratio of RTP Packet sequence numbers missing over
the number of RTP Packets entering the Seamless
Protection block on interface Port 2 has exceeded the
user defined alarm threshold.
The ratio is continuously evaluated over the preceding
30 seconds.
Seamless Switching Excess Skew 1153 When Seamless Protection mode is enabled and thus
the measured skew between interface Port 1 and Port 2
has exceed the user defined alarm threshold
The skew is continuously evaluated over the preceding
30 seconds.
C.2.14. 4:2:2 Decoder Card Alarm Identifiers
Table C.13 4:2:2 Decoder Card Alarm Identifiers
Name Identifier Description
TS not locked on 422 card 1400 The 4:2:2 Decoder card does not detect an incoming
Transport Stream for decode.
Not supported by the MPEG-2 4:2:2 Decoder Card (First
Generation).
Decoder not ready on 422 card 1401 The 4:2:2 Decoder is in a reset state and currently not
ready for video decode.
Not supported by the MPEG-2 4:2:2 Decoder Card (First
Generation).
Decoder error on 422 card 1402 Decoding errors detected by the 4:2:2 Decoder card.
Not supported by the MPEG-2 4:2:2 Decoder Card (First
Generation).
Code version error on 422 card 1403 Activated when the code version loaded on the 4:2:2
Decoder Option card is not compatible with the
motherboard code version.
As of motherboard code version 7.14.0 onwards, the
minimum supported code version for the Third
Generation 4:2:2 Decoder Option card is 3.0.
Decoder not locked to system clock
on 422 card
1404 Alarm to indicate when the decoder 422 card is free
running i.e. Not locked to the system clock.
To Next Page
Loading...
