EasyManua.ls Logo

MediaKind RX8000 - IP Input Alarm Identifiers; Miscellaneous Input Alarm Identifiers

MediaKind RX8000
483 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
RX8000 Integrated Receiver/Decoders
1553-FGB 101 759 Uen K
www.mediakind.com
C-6
C.2.11. Miscellaneous Input Alarm Identifiers
Table C.10 Miscellaneous Input Alarm Identifiers
Name Identifier Description
SNR 1080 Signal/Noise Ratio below threshold on ATSC 8VSB input
C/N Margin 1081 Carriage/noise margin below threshold on DVB-S2
Satellite input
G.703 Input Option Card Alarm 1082 General alarm from G.703 input
DVB-T2 Temperature 1083 Over temperature
DVB-T2 Software Error 1084 General error
DVB-T2 MER 1085 MER threshold
DVB-T2 BER 1086 BER threshold
DVB-T2 Power 1093 Diagnostics
Frame Sync Out of Sync 1094
Frame Sync is enabled but is not synchronized with the
current video frame rate or no signal is detected on the
Frame Sync input.
C.2.12. IP Input Alarm Identifiers
Table C.11 IP Input Alarm Identifiers
Name Identifier Description
IPI Ethernet If 1 Down 1100 Link down on port 1
IPI Ethernet If 1 No Data 1101 No data being received on port 1
IPI Ethernet If 1 IP Conflict 1102 Assigned IP address conflicts with other equipment on
network
IPI Ethernet If 2 Down 1103 Link down on port 2
IPI Ethernet If 2 No Data 1104 No data being received on port 2
IPI Ethernet If 2 IP Conflict 1105 Assigned IP address conflicts with other equipment on
network
IPI Ethernet If 1 and 2 Down 1106 Link down on both port 1 and 2
IPI Ethernet If 1 and 2 No Data 1107 Data data is being received on both port 1 and 2
Port 1 net util 1108 Network utilization is above threshold
Port 2 net util 1109 Network utilization is above threshold
MDI delay factor 1110 The delay factor is greater than set value
MDI loss rate 1111 The loss rate is above set value
Out of sync 1112 The card has failed to lock to a valid TS
No response 1113 No response on link
Wrong FEC format 1114 Wrong FEC format
FIFO overflow 1115 FIFO overflowed
Primary interface not in use 1116 If redundancy switch to secondary has occurred
Primary TS not in use 1117 If redundancy switch to secondary TS has occurred
All TSs missing at all input IFs 1118 If no multicast is available

Table of Contents

Other manuals for MediaKind RX8000

Related product manuals