RX8000 Integrated Receiver/Decoders
1553-FGB 101 759 Uen K
www.mediakind.com
• Link Config – The link speed of the control port. This can be:
• 10 BaseT
• 10 BaseT Half Duplex
• 100 BaseT
• 100 BaseT Half Duplex
• Auto
• MAC Address – Displays the MAC address assigned to this
control port (non-editable).
• Link Status – Displays the operating speed and mode of the
established Control link (e.g. 100 Mb Full Duplex).
If the IP address of Control 1 and Control 2 are set to the same value, the
MAC Address of Control 2 will be automatically adjusted to match that of Control
1.
3.9.2.3.2. Common
• Gateway – The Gateway address common for both networks
(Control 1 and 2).
3.9.2.3.3. Network Time Update
The implemented Simple Network Time Protocol (SNTP) client is able to synchronize the system time
with second tier NTP servers.
Configuration is only possible via the web browser interface on the page Device Info > Network
Settings.
•
Network Time Update – ON/OFF.
• Time Zone – GMT + 12.
• Daylight Saving – ON/OFF.
• NTP Server No 1 – IP Address.
• NTP Server No 2 – IP Address.
• NTP Server No 3 – IP Address.
• NTP Server No 4 – IP Address.
If the SNTP interface is not being used, its associated alarm should be
masked.
If the input stream contains TDT, this will override the NTP server derived time.
3.9.2.3.4. DSM Parameters
Device Status Message (DSM) packets and Control Status Message (CSM) packets are an MediaKind
proprietary protocol used within an nCC network to control redundancy. These packets are IP
datagrams on specific IP addresses; they are used to provide the current health of the unit / network
To Next Page
