RX8000 Integrated Receiver/Decoders
1553-FGB 101 759 Uen K
www.mediakind.com
Board Type Description
1936 Enhanced Multi Format 4:2:2 Decoder, 4
th
generation (RX8200 only)
3.9.2.6. Device Info > Trap Destination Table
When an alarm occurs within the equipment, an SNMP Trap message is sent to all destinations and a
list of these destinations is given in this web page.
The SNMP alarm trap sent will contain sysUpTime. This is the elapsed time
since the SNMP agent was reinitialized and this is not configurable on the IRD
To view this page, select the Trap Destination button from the Device Info page.
Figure 3-23 Device Info > Trap Destination Table Web Page
To add a new item to this page:
1. Select the Add Item button. The following page is displayed:
Figure 3-24 Trap Destination Table > Add Item Web Page
2. Enter the required values in the appropriate fields or select values
from the drop-down menus.
3. Select the Add button to add the item to the Trap Destination table.
4. Select the Back button to return to the Device Info > Trap
Destination Table web page. This will abort any unsaved changes.
5. Select the Apply Changes button to confirm changes.
Selecting the Refresh button will ensure that the latest information is being displayed from the
current values of the equipment.
To Next Page
