User Manual Thermal Unit TES Valida
Page 12 Rev. 04(12/2013)
Medite GmbH
.
Wollenweberstr. 12
.
31303 Burgdorf
.
Germany
Phone +49 5136 88 84 0
.
Fax +49 5136 88 84 55
.
info@medite.de
.
www.medite.de
5 Operation
5.1 Switching the unit on
Press the mains switch on the rear of the instrument. The unit is now in standby mode, which is
indicated by the word OFF in the display.
Press the Power Key (figure 7 (8)) at the controller to activate the Thermal Unit. The unit is now in
default, where it shows the current temperature settings of both circuits. The temperature of the pre-
warming chamber is indicated by an upward arrow, while a downwards arrow indicates the
temperature of the warming tray. Ten seconds after last use, the unit always comes back to the
default.
5.2 Switching the unit off
Press the Power Key (figure 7 (8)) at the temperature controller to deactivate the dispenser unit. The
device is now in Stand-by, which can be recognized by the word OFF shown in the display.
For complete turn-off, use the main switch on the rear of the device, and put it in position “O”.
If you wish to disconnect the device completely from power supply, please remove the mains plug
from the safety socket.
5.3 Temperature Circuits
The thermal unit has two circuits, that are shown in the display. The digits on the left of the display
with the downwards arrow indicate the temperature of the warming tray. The digits on the right of the
display with the upwards arrow indicate the temperature of the prewarming chamber. To choose one
circuit, use the applicable direction key.
To Next Page