Medite TES Valida - 2 Safety; Transport; Installation; Working with the TES Valida Thermal Unit

User Manual Thermal Unit TES Valida
Page 7 Rev. 04(12/2013)
Medite GmbH
.
Wollenweberstr. 12
.
31303 Burgdorf
.
Germany
Phone +49 5136 88 84 0
.
Fax +49 5136 88 84 55
.
info@medite.de
.
www.medite.de
2 Safety
2.1 Transport
When moving the TES Valida™ Thermal Unit, please carefully consider the following directions for
safety of the device and user.
2.2 Installation
The TES Valida™ Thermal Unit must be placed on an even and solid basis. A falling down instrument
means danger of accident.
2.3 Working with the TES Valida™ Thermal Unit
Unauthorized changes and technical modifications of the instruments are not permitted
for safety reasons. For the exchange of defective parts, only original Medite® spare
parts are to be used.
Any failure to comply with the approved technical regulations for the operation of
technical equipment or any non-intended use of the instrument will void the
manufacturer’s liability.
 Use the device only with the allowed power supply.
 Do not use the device in explosion-risk areas.
 Safety devices on device and accessories are not to be removed or modified.
 Do not place the device with its back directly to a wall. Arrange for a safety
distance of minimum 10 cm.
When working with the TES Valida™ Thermal Unit, take personal safety measures.
Caution! Parts of the Thermal Unit can reach high temperatures.
This pictogram of arrows indicates which side is up on the packed device. Always
move, handle and store so that the arrows point up. Rolling, folding, hard tilting as well
as other forms of handling need to be avoided.
This pictogram indicates that the packed device is to be proteced from moisture. It
needs to be covered when stored and moved.
When working with the TES Valida™, only use Paraffin without DMSO!