Medite TES Valida - 6 Failure, Errors and Other Problems; Change of Fuses; Error Messages

User Manual Thermal Unit TES Valida
Page 17 Rev. 04(12/2013)
Medite GmbH
.
Wollenweberstr. 12
.
31303 Burgdorf
.
Germany
Phone +49 5136 88 84 0
.
Fax +49 5136 88 84 55
.
info@medite.de
.
www.medite.de
6 Failure, Errors and other Problems
6.1 Change of Fuses
In case of failure of the device, check the fuses in the fuse holder, which is integrated in the instrument
socket at the rear. Proceed as follows:
 Pull out the mains plug
 Open fuse holder with a screw driver
 Change the fuse (only use original Medite® material)
 Close the fuse holder
 Connect to mains and try again
In case of any other defect, or if the described procedure is not successful, contact the Medite®
Service Department.
6.2 Error messages
Indicated Message
Cause
Solution
F1L, blinking
Sensor error; short circuit
Call Service Engineer
F1H, blinking
Sensor error; broken sensor
Call Service Engineer
F2L, blinking
Sensor error; short circuit
Call Service Engineer
F2H, blinking
Sensor error; broken sensor
Call Service Engineer
EP, blinking
Lost data in parameter memory
Call Service Engineer
Set Clock, continuous
Lost real time
Set real time (see 5.4.1)
Only Medite® authorized service engineers are allowed to correct the correspondingly
marked errors. Do not try it yourself!
Never remove any parts of the casing while the instrument is on power.
(1) Notch
(2) Fuse drawer
(3) Fuses
figure 8
First pull out the mains plug!
It is only permitted to use UL accredited fuses, that are available at Medite®!
(2)
(1)
(3)