Medite TES Valida - Time Settings; Set Real Time; Set Weekly Timer

User Manual Thermal Unit TES Valida
Page 15 Rev. 04(12/2013)
Medite GmbH
.
Wollenweberstr. 12
.
31303 Burgdorf
.
Germany
Phone +49 5136 88 84 0
.
Fax +49 5136 88 84 55
.
info@medite.de
.
www.medite.de
5.5 Time settings
5.5.1 Set Real Time
To set the weekly timings, the real time must be set first. If it is not set, the display shows the marquee
Set clock.
Press the Clock Key (figure 7 (1)) for two seconds. The display then shows a blinking time. Blinking
means, that the shown value can be edited. The blinking will stop once you start the setting in order to
avoid irritations. Use the direction keys to set the time. Press the Clock Key again when you are done
to save the current time. The display then shows the blinking word Day with a code number between 1
and 7. This number stands for the current week day. Choose the current week day by using the
direction keys, and confirm the input by pressing the Clock Key again. You have now set your local
time and day.
Current Week Day
Code
Monday
1
Tuesday
2
Wednesday
3
Thursday
4
Friday
5
Saturday
6
Sunday
7
If the setting is not confirmed or processed for ten seconds, the process is cancelled.
When the power supply is off for a considerable time, it is possible that the real time gets lost.
5.5.2 Set Weekly Timer
With the weekly timer, automatic start and end times can be preset in 24 hours mode. It is important
that the real time is set (see chap. 5.5.1 Set Real Time).
Choose the circuit you want to set up by using the direction keys when in default.
Press the Set Time Key for two seconds. The display then shows a figure (1 – 7, see Chapter 5.5.1
Set Real Time), an I and a four-digit time indication with a colon in the middle. The I stands for
Activate, and the time indication is the starting time.
Read “1 I 10:15” as “On Monday, timer starts at 10:15 a.m.”.
Press Set Time Key again and then use the direction keys to set the starting time. When you’re done,
press Set Time to save your input. You’ll get back to the display showing the preset time. With the
direction keys, you can switch from this display to any week day and set start and end times. Setting
the ending time is the same procedure.