MediWorks S360 - Technical Specifications; Instrument Marks and Specifications

Slit Lamp Microscope USER MANUAL
7 / 29
should be less than the compliance level in
each frequency range.
Interference may occur in the vicinity of
equipment marked with the following
symbol:
Recommended separation distances between portable and mobile RF communications equipment and the ME
EQUIPMENT and ME SYSTEM – for ME EQUIPMENT and ME SYSTEM that are not LIFE-SUPPORTING.
Recommended separation distances between portable and mobile RF communications equipment and the
S360 /S390L WDR
The S360/ S390L WDR is intended for use in an electromagnetic environment in which radiated RF
disturbances are controlled. The customer or the user of the S360 /S390L WDR can help prevent
electromagnetic interference by maintaining a minimum distance between portable and mobile RF
communications equipment (transmitters) and the S360/ S390L WDR as recommended below, according to
the maximum output power of the communications equipment.
Rated maximum
output power of
transmitter
W
Separation distance according to frequency of transmitter
m
150kHz to 80 MHz
P
V
d ]
5.3
[
1

80MHz to 800MHz
P
E
d ]
5.3
[
1

800MHz to 2.5GHz
P
E
d ]
7
[
1

0.01
0.12
0.12
0.23
0.1
0.37
0.37
0.73
1
1.2
1.2
2.3
10
3.7
3.7
7.3
100
12
12
23
WEEE precautions：
Please dispose the waste electrical and electronic equipment in accordance with relevant regulations
and laws.
1 Technical specifications
1.1 Instrument Mark and Technical Specification
The slit lamp microscope is powered by network power supply. The following marks are required permanently
affixed to the instruments according to IEC 60601-1Standard. The following table lists the tips for your
reference.
Table two:
No.
Content
Instructions