Meec tools 703-040 - Troubleshooting

ENGLISH
96
TROUBLESHOOTING
WARNING: Switch off the tool and unplug the power cord before troubleshooting.
The troubleshooting schedule below indicates problems and possible solutions. Contact your dealer if you
cannot solve the problem with the troubleshooting schedule.
Problem
Cause
Action
The chain saw does not work
• No power supply
• Defective plug
• Damaged extension cord
• Tripped fuse
• Check the power supply
•
Try other power source,
and replace if necessary
•
Check power cord and
replace if necessary
• Replace the fuse
The saw does not work
continuously
• Power cord damaged
• External loose contact
• Internal loose contact
• Power switch defective
• Contact your dealer
• Contact your dealer
• Contact your dealer
• Contact your dealer
Chain is dry
• No oil in the tank
• Ventilation hole
• in oil filler cap clogged
• Oil duct clogged
• Replenish oil
• Clean oil filler cap
• Clear oil duct
Chain/bar hot
• No oil in the tank
• Ventilation hole
• in oil filler cap clogged
• Oil duct clogged
• Blunt chain
• Replenish oil
• Clean oil filler cap
• Clear oil duct
• Sharpen chain, or replace
Chain saw falters, vibrates or
does not saw properly
• Chain not properly tensioned
• Blunt chain
• Worn chain
• Misaligned teeth
• Adjust chain tension
• Sharpen chain, or replace
• Replace chain
• Fit chain again with teeth in
right direction
Chain saw falters, vibrates or
does not saw properly
•
Chain not properly tensioned
• Blunt chain
• Worn chain
• Misaligned teeth
•
Adjust chain tension
• Sharpen chain, or replace
• Replace chain
• Fit chain again with teeth in
right direction