Why is the chain/bar on my Meec tools 703-040 Pole Saw hot?
If the chain/bar of your Meec Tools Pole Saw gets hot, it could be due to several reasons: * There might not be enough oil in the tank, so replenish the oil. * The ventilation hole in the oil filler cap could be clogged, so clean the oil filler cap. * The oil duct might be clogged, so clear the oil duct. * The chain could be blunt, in which case you should sharpen or replace it.
How to fix a dry chain on my Meec tools 703-040?
If your Meec Tools Pole Saw chain is dry, it could be due to: * No oil in the tank: Replenish the oil. * Ventilation hole in oil filler cap clogged: Clean oil filler cap. * Oil duct clogged: Clear oil duct.
What to do if my Meec tools 703-040 does not work?
If your Meec Tools Pole Saw does not work, consider the following possible causes and solutions: * No power supply: Check the power supply. * Defective plug: Try another power source, and replace the plug if necessary. * Damaged extension cord: Check the power cord and replace if necessary. * Tripped fuse: Replace the fuse.
Why does my Meec tools 703-040 falter, vibrate, or not saw properly?
If your Meec Tools Pole Saw falters, vibrates, or does not saw properly, it could be due to: * Chain not properly tensioned: Adjust the chain tension. * Blunt chain: Sharpen or replace the chain. * Worn chain: Replace the chain. * Misaligned teeth: Fit the chain again with the teeth in the right direction.
General electrical safety precautions for power tools.
Essential personal safety measures and protective equipment.
Specific safety advice for operating chain saws.
Procedure for correctly adjusting the chain tension.
Procedures and safety for felling trees with the pole saw.
General| Chain Pitch | 3/8" |
|---|---|
| Max Cutting Diameter | 20 cm |
| Power Source | Electric |
| Voltage | 230 V |
| Chain Gauge | 1.3 mm |
To Next Page