Meech HYPERION 233v4 - Ion Level Monitoring and Reset; Instantaneous Ion Level Measurement; Resetting the Ion Reference

32 pages

To Next Page

To Previous Page

Ion Level

This is an instantaneous measure of the performance of the ioniser,

compared to its performance when new and clean. A low percentage could

indicate that the ioniser needs cleaning.

Reset Ion Ref.

This funcon is used to set reference performance level when the ioniser is

clean. It is set by Meech during inial calibraon. It should be reset aer

making changes to either the balance or the frequency of the output.

WARNING

Only reset the Ion Reference with the ioniser connected and clean. Failure

to do so will result in an incorrect calibraon.

Please see BarMaster operang manual for more informaon.