Meech HYPERION 233v4 User Manual

25
Fault Finding
Tests must be completed by a qualied electrical engineer.
If in doubt contact the Meech head oce or your local distributor.
CAUTION:
Whilst no danger to personnel exists, it is essenal that any high voltage
ionising equipment makes no contact with water or water based uids.
Should such an event occur, disconnect immediately and return equipment to
the manufacturer for water damage assessment.
The table below idenes the meaning of the LED display on the 233v4. A
Meech Barmaster or SmartControl Touch is required to make a full diagnoses
and adjustments to the system.
LED
When the equipment powers on, the LED will show green whilst the system
monitors the ionisers performance. If it then starts to ash red or go solid
red, check the ion level with the BarMaster or SmartControl Touch.
No Light Meaning No power to power supply
Acon Check that the power supply is connected
properly. If you have electrically installed
the unit, ensure that the installaon is
correct (see electrical installaon page
10)
Solid Green
Meaning Power supply OK
Acon No acon required
Flashing Green
LED
Meaning Power supply OK, BarMaster connected
Acon Remove BarMaster when sengs are
correct. Re-aach power supply when
BarMaster removed

Meech HYPERION 233v4 Specifications

General

Brand	Meech
Model	HYPERION 233v4
Category	Controller
Language	English