Check that the unit has not been damaged during transport
Protection Against Fire
1. Maintain a minimum of 1 foot distance from any type of flame.
2. This equipment is designed to be used only with the following lamp:
1 MSR 575/2
2 MDS 575
3.NSK 575
3. Replace fuse only with the specified type and rating.
4. Do Not install the unit to close to a heat source.
5. Make sure cable are properly secured away from unit movement.
6. Maximum surface operating temperature 80º.
Protection Against Fire
1. Disconnect power before lamp replacement or servicing.
2. For connection to main power supply proceed to page 4.
3. This unit must be earthed. (electronically grounded)
4. Do not expose unit to rain or moisture.
Protection Against Mechanical Hazards
1. Make sure head movement is not blocked.
2. Use safety chain when hanging unit
3. Unit surface may reach high temperature. Allow about 5 minutes after lamp has been turned off be-
fore moving.
4. Replace lamp before it exceeds the lamp life.
Protection Against UV Radiation
1. Do not look directly at the lamp when cover are off and lamp is on.
2. Do not start unit with out lamp covers or if the protection screens, or ultraviolet filters.
3
To Next Page
Loading...
